Sheet Metal Brake

From Freeside Atlanta
Revision as of 07:03, 15 February 2013 by AUGuru (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
30inch Metal Brake.jpg

Contents

Zone

Equipment \ Warehouse \ Metal Shop

Owner(s)

  • Randy Farmer

Permissions

For general use by members. Treat equipment as if it were your own and put away as or better than you found it. Contact owner with questions or issues.

Restrictions

  • Metal and bendable sheet goods only. Do not use on wire.
  • For up to 18 gauge steel
  • For up to 16 gauge aluminum
  • Material being bent should be clean and rust free
  • The two c-clamps belong with the brake and should be stored with it

About

For bending thin sheet metal up to 90 degrees.

Basic Instructions

Mark or Score metal along the intended bend
Use clamps to secure sheet to bend with the pressing plate on top.
Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.


Specifications and Detailed Instructions

Info.jpgHarbor Freight 30" Bending Brake
RTFM.PNGPDF Manual
Video.jpgGood YouTube demonstration of this style brake

Warnings

Crush.png Crush and Pinch Risk

Safety

Goggles.PNG Eye Protection Required

Personal tools
Namespaces

Variants
Actions
About Us
Support Us
Activities and Culture
Membership
Outreach
Leadership
Teams
Organization
Toolbox